Quote:
Originally Posted by Cape Codder
I just measured two disttributor bodys I have and each one measured .993-.994 above and below the grove. One of the ones I measured is in the car ( happened to me doing some maintenance).
Hope this helps. Oh, by the way the one in the car is snug>
Cape Codder
|
Cape Codder, thanks for taking the time to measure your distributer bodies. However, I'm not sure what it is that you measured. My upper body has a machined area where it mates to the base. When I measure the inside diameter of the body in the machined area I get 2.89" or about 73mm. How does that compare with yours?
Quote:
Originally Posted by Tom Wesenberg
Someone is making a repro distributor body with only ONE alignment notch, as original. I haven't tried one yet to see how tight they fit the distributor.
|
Tom, if I'm understanding correctly what you mean by "alignment notches", mine appears to have two, so does that mean it's a repro?
Thanks for your help.