The Ford Barn - View Single Post

duncrd · 05-29-2026, 11:10 PM

Barnfind08-i am now in same place as this fellow was in 2023. I am in need of .080 over cam bearings for 59AB build. I finally ended up with good block after 3 unusable ones. Cylinder bores cleaned up at .040 over then the F1 durabond cam bearings too small. Any help is greatly appreciated.
Thanks
Ron

05-29-2026, 11:10 PM	#14
duncrd Junior Member Join Date: Aug 2012 Location: Indianapolis Posts: 4	Re: 59ab 80 over cam bearing Barnfind08-i am now in same place as this fellow was in 2023. I am in need of .080 over cam bearings for 59AB build. I finally ended up with good block after 3 unusable ones. Cylinder bores cleaned up at .040 over then the F1 durabond cam bearings too small. Any help is greatly appreciated. Thanks Ron