[ratmother]

I have a Bolt Buster and like it a lot. So far, it’s handled everything I’ve thrown at it. I prefer it over oxy-acetylene - targets the heat well and avoids open flame.
As far as recommendations, be patient if removing head, manifold or water pump studs. I heat and cool the stud and melt a little candle wax into the threads after heating. If the stud wants to bend, I weld an oversize nut close to the block and use an induction heater attachment that fits around the nut to continue the heat/cool cycle and to let me use a wrench versus stud remover.
Patience works for me.😎☘️