Quote:
Originally Posted by Diastole
Thank you for all the great advice
The original studs are 1/2“ x 20 tpi
According to Les Andrews, all I need to do is get to 35 to 40 foot pounds of torque
Each side of the bearing cap had two shims
I doubt the studs were stretched out
I will plasti-gauge when I put it back together
Diastole in the Smokies
|
Are you sure? Snyders shows then as 7/16-20.
https://www.snydersantiqueauto.com/p...8702&cat=41684