The Ford Barn - View Single Post

cas3 · 04-13-2026, 10:57 PM

I agree with Tim, its the seal surface, the 34 had no seal. I did one with the kit from Lecy, v8 garage, and my spacers were a bit loose too. I peened the spindle a bit, then red locktite. I also welded up the holes in the backing plate and re drilled to 34 spindle size.

04-13-2026, 10:57 PM	#4
cas3 Senior Member Join Date: Jan 2011 Location: Beverly Kansas Posts: 5,558	Re: Adapting hydraulic brakes to 34 spindle I agree with Tim, its the seal surface, the 34 had no seal. I did one with the kit from Lecy, v8 garage, and my spacers were a bit loose too. I peened the spindle a bit, then red locktite. I also welded up the holes in the backing plate and re drilled to 34 spindle size.