The Ford Barn - View Single Post

Andy · 03-22-2026, 10:57 AM

My 32 block was bored to use cam bearings. I would like to know the stock diameter of the holes. The new bearings were too tight. I suspect the bores are undersized.
Thanks!

03-22-2026, 10:57 AM	#1
Andy Senior Member Join Date: May 2010 Location: Kerrville, Tx Posts: 2,919	Stock block cam Bering hole diameter? My 32 block was bored to use cam bearings. I would like to know the stock diameter of the holes. The new bearings were too tight. I suspect the bores are undersized. Thanks!