The Ford Barn - View Single Post - What brand recommendation for lock ring pliers

Tim Ayers · 02-09-2026, 11:02 AM

Robert,

This can be one of the most frustrating jobs. I use a set of Craftsman pliers (part # 47386) but I believe they are made for them by Lang Tools for this job.

That said, often these are not enough. I use these pliers to get the rings separated, and somewhat lifted and then insert a thin flat bladed screw driver under it and use that to get the ring pried out of the recess.

Highly advisable to get a set of Mac VP's modified lock rings which allow the plier to actually grab the ends.

Good luck. It can a be a very frustrating task getting these out on the first shot.

02-09-2026, 11:02 AM	#2
Tim Ayers Senior Member Join Date: May 2010 Location: NJ Posts: 7,233	Re: What brand recommendation for lock ring pliers Robert, This can be one of the most frustrating jobs. I use a set of Craftsman pliers (part # 47386) but I believe they are made for them by Lang Tools for this job. That said, often these are not enough. I use these pliers to get the rings separated, and somewhat lifted and then insert a thin flat bladed screw driver under it and use that to get the ring pried out of the recess. Highly advisable to get a set of Mac VP's modified lock rings which allow the plier to actually grab the ends. Good luck. It can a be a very frustrating task getting these out on the first shot.