The Ford Barn - View Single Post - Need Help To Identify 35 Ford Sheet Metal Parts

32Bee · 01-25-2026, 10:20 AM

Henry Ford IV. After having spent many hours assembling my 35 convertible sedan which
had been completely apart for over 40 years, I'd like to pass on this advice concerning the
small front fender braces. Don't snug them up tightly until your front fenders have been
installed and you see how well the center hole in the main bracket lines up with the hole
that the headlamp stud inserts through. There is the ability to slightly adjust the fender
bracket hole with the small diagonal brace on each side.

01-25-2026, 10:20 AM	#9
32Bee Senior Member Join Date: May 2010 Location: Stratham, NH Posts: 296	Re: Need Help To Identify 35 Ford Sheet Metal Parts Henry Ford IV. After having spent many hours assembling my 35 convertible sedan which had been completely apart for over 40 years, I'd like to pass on this advice concerning the small front fender braces. Don't snug them up tightly until your front fenders have been installed and you see how well the center hole in the main bracket lines up with the hole that the headlamp stud inserts through. There is the ability to slightly adjust the fender bracket hole with the small diagonal brace on each side.