[Kube]

Originally Posted by JayChicago

AI said:
"When starting, the resistor allows a higher voltage to reach the coil temporarily.
This provides a hotter spark for easier engine starting, which is crucial in older vehicles."

I don't get this statement. (I know this is AI generated, which often gets bum info when it searches the internet) Is there any truth to this as it applies to our cars?

Many later cars did work this way. A 12 volt to 8 volt ballast resistor was bypassed during cranking.

But on our cars, the resistor is always in the circuit. I have measured the voltage reduction as the resistor gets hot, is only a few tenths of a volt. So don't see how, on our cars, the resistor helps start-up. Am I missing something about how a resistor functions?

Jay, you are not missing anything. The resistor in our old Fords operates all the time.