Re: would an A carb on a B manifold have less power than A on A?
The original poster talked about using a Model A manifold that was bored out for a Model B carburetor. In that case I don't see any issues with hooking up the controls. Aside from the dead flow area that Brent talked about, the bored out manifold should allow better breathing and thus performance, especially at higher rpm.
__________________
A is for apple, green as the sky.
Step on the gas, for tomorrow I die.
Forget the brakes, they really don't work.
The clutch always sticks, and starts with a jerk.
My car grows red hair, and flies through the air.
Driving's a blast, a blast from the past.
|