[California Charlie]

Thanks 1955cj5 for the photo. Where did you purchase your clutch release lever?

It appears the shaft that comes out of the Bell Housing, and what the clutch release lever attaches to, is drilled incorrectly.

Front what photo's I've seen the shaft hole the pin inserts to hold the clutch release level is at a 12 o'clock shaft position. The shaft coming out of my Bell Housing is at a 2 o'clock position which positions the clutch release lever so low the trunnion can't reach.

At this point in time my options are:

1. Comletely disassemble the Bell Housing and replace the clutch release lever shaft.
2. Plug the shaft hole that is currenlty in a 2 o'clock position and try to drill a new straight 12 o'clock hole without removing the Bell Housing etc.
3. Extend the trunnion and see how that works.

I'm currently leaning towards trying #3.

I don't recall the vendor I used to purchase the Bell Housing shafts.