The Ford Barn - View Single Post

Karl Wescott · 02-15-2025, 10:35 AM

A thought...

If you can get the battery cables to fit well enough to work properly but the post is too low, consider making a dummy 3D extension of the post which should be able to look good and get squished slightly on installation to keep it in place.

02-15-2025, 10:35 AM	#91
Karl Wescott Senior Member Join Date: May 2010 Location: Oregon Posts: 1,663	Re: 3D Printed Ford Battery Case Help A thought... If you can get the battery cables to fit well enough to work properly but the post is too low, consider making a dummy 3D extension of the post which should be able to look good and get squished slightly on installation to keep it in place.