Quote:
Originally Posted by birdball
I had that cam in my sedan. 255” motor, 4” crank with 2x2. Ran great sounded amazing but not a ton of low end. I’ll try to post a video if I can figure it out…
**edit** my apologies! I miss read your question and you were asking about the 6015 cam- my post was for the 6014 cam. There is a video below anyway!
Attachment 558849
Attachment 558850 |
Thanks for the response, that motor sounds great! I have a bone stock '37 21 stud flathead and would like to install a cam, dual carbs...basic hop up parts. I'm assuming this would be too radical of a camshaft?
Thanks Gabe