Re: 276 stroker from 35 years of parts
I believe the end play on the shaft/gear assembly in the pump body is controlled by the drive gear clearance to the pump housing. That play should not allow the pumping gear to bear against the end plate so while checking clearances that's a good one to look at.
Yes, proper gasket is around .004-.006 from what I've seen. May not require one if checked and clearance is good.
__________________
"It don't take but country smarts to solve the problem" (Smokey Yunick)
'30 Model A Speedster
'41 Merc Town Sedan / 260" 8CM engine
'66 Fairlane four door / "warmed up"  302
|