Re: Repairing worn hub axle races
When this is done to the axle housing, the owner is usually looking to do up the whole of the bearing which includes the inside of the hub. When the sleeve is inserted in there, a tube of Loctite 660 (supplied with the kit) is used to hold it in place.
If the interference between the smaller sleeve (shown in the video clip) and the axle housing is not enough, could the same Loctite compound be used to hold it? I suspect so even though I would prefer the correct interference.
__________________
I'm part of the only ever generation with an analogue childhood and a digital adulthood.
|