The Ford Barn - View Single Post

pistonbroke · 12-12-2023, 10:01 AM

I did 3/16's but don't make the same mistake
I did. Drill the holes as low down on the lifter bore wall as possible, about half of mine were just to high so the holding tool wouldn't quite pass into the lifter, Tim

12-12-2023, 10:01 AM	#4
pistonbroke Senior Member Join Date: Feb 2021 Location: Perry Mo. Posts: 838	Re: lifter bore adj hole I did 3/16's but don't make the same mistake I did. Drill the holes as low down on the lifter bore wall as possible, about half of mine were just to high so the holding tool wouldn't quite pass into the lifter, Tim