The Ford Barn - View Single Post

8EL · 10-27-2023, 08:18 PM

OD of bushing follows circumference of bore. The reason I was questioning its installation is because the top edge of the bushing partially covers the hole machined for the speedometer drive gear housing. The housing does bolt up however with the driven gear installed.

What of the difference in height of the new and old bearings?

10-27-2023, 08:18 PM	#3
8EL Senior Member Join Date: Jul 2023 Posts: 256	Re: Torque Tube Bushing OD of bushing follows circumference of bore. The reason I was questioning its installation is because the top edge of the bushing partially covers the hole machined for the speedometer drive gear housing. The housing does bolt up however with the driven gear installed. What of the difference in height of the new and old bearings?