Rebuilding my Flathead random questions
I am rebuilding my first Flathead. Please don’t tell me to leave it up to the pros. That's boring and there are none around me. Anyway, below are the specs and my first question as I start to put this together. I will use this thread for the random questions I have along the way rather than starting a new thread every time.
Car
40 coupe, stock drivetrain, upgraded brakes and suspension.
Engine Specs
40 block
4” crank
3 3/16 pistons (stroked crank taken into account)
8ba rods
Isky max 1 cam
Adjustable lifters with holes drilled for adjusting
Edelbrock aluminum heads
Dual 97’s on an edmunds intake
My first question is, is it ok to use the steel crank gear up against an aluminum cam gear? Somewhere I read this was not ok? Please confirm.
Last edited by busmania; 08-09-2023 at 06:22 PM.
|