Quote:
Originally Posted by Ol' Ron
Yes, for floaters, I run about .002 on both the rods and crank. I open the rods to 2.221 and the crank to 1.997. OR find bearings that are .1o8" thick. That's why fitting the bearings are important. Again, I have dozens of used bearigs to choose from
|
Hello Ron,
I am just checking my crank and rods. It`s 81A motor. So again about floaters which i have. You say .002 on both ..does it mean .001 between journal OD and bearing ID + .001 between bearing OD and rod ID ?
Or maybe you mean .002 + .002 = .004 total ?
Greetings