Re: How nat of you are using engine/motor pans?
I can see how the mounting points would crack so I wonder about mounting them on rubber like they use on the number plates, indicators etc on motor cycles.
It's easy to make a double ended bolt for holding the sump and to attach the pans. That covers that side of them. Weld a nut on the inside of the chassis (or tap the hole) where they attach there. Put a rubber sleeve above and below the pan all held in place by a nut and washer. I'd use a Nylock nut, I think. That should leave them mounted softly enough that they won't crack.
__________________
When all is said and done, more is said than done. That's why we judge people on what they do, not what they say.
I sometimes wonder what happened to the people who asked me for directions.
If I am not in trouble, I've done something wrong.
|