The Ford Barn - View Single Post

Brentwood Bob · 11-30-2022, 02:10 PM

When I welded up and redrilled my frame I used the holes on the passenger side as my guide. Made a pattern with cardboard and spray paint. Then welded up one hole, marked it and redrilled. I had a brass bracket, probably an early aftermarket fix, to fine tune the new hole with the bracket bolted to the remaining original hole in the frame. Then reversed the procedure to get the other wallowed out hole done.

11-30-2022, 02:10 PM	#9
Brentwood Bob Senior Member Join Date: May 2010 Location: brentwood, ca Posts: 4,502	Re: Pitman arm interference issue When I welded up and redrilled my frame I used the holes on the passenger side as my guide. Made a pattern with cardboard and spray paint. Then welded up one hole, marked it and redrilled. I had a brass bracket, probably an early aftermarket fix, to fine tune the new hole with the bracket bolted to the remaining original hole in the frame. Then reversed the procedure to get the other wallowed out hole done.