Quote:
Originally Posted by bmwillia
This thread is great!
I Just got a fresh built 59ab for my 33 coupe.
Any measurements on where to cut the double crank pulley, or is it ok to cut at the base of the cone for the front pulley?
I also need to fabricate some spacers. What should the overall height of the spacer be?
|
If you look down the bore of the pulley, there is a step where the bolt and washer bear against. You should shorten the main body until it is flush with that shoulder. That way the bolt works exactly as it did before.
I made spacers for my 33. I used some square tubing plus an extra packer. I can't remember the exact height I achieved but it is about 1-3/4". The holes need to be offset outboard 1/2" each side. This is from memory please check dimensions o0n your vehicle.
Mart.