The Ford Barn - View Single Post

dave in australia · 09-22-2022, 02:30 AM

When did Ford swap from the machined input/output main bearing stops in casing to the snap ring stop?

When did Ford swap from the reverse idler shaft with the cup for lubrication to the idler with a drilled hole in the actual gear?

09-22-2022, 02:30 AM	#1
dave in australia Senior Member Join Date: May 2010 Location: Victoria, Australia Posts: 1,179	Two gearbox questions When did Ford swap from the machined input/output main bearing stops in casing to the snap ring stop? When did Ford swap from the reverse idler shaft with the cup for lubrication to the idler with a drilled hole in the actual gear?