Quote:
Originally Posted by Yoyodyne
How is that done?
I've read here in the past that the bearing shell can be shimmed a few thousandths to adjust end play, is that a reasonable thing to do?
|
Same principal as if you were sleeving the middle of the saddle. You bore away about .080 from the area covered by the side of the shell, then make a flat curved piece to fit in the bored away area. Make the insert about .010 to .015 thicker than the finish thickness for the saddle.
Clamp the new piece in place with a generous amount of Loctite and drill 4, 1/8 holes evenly spaced across the piece. Take a short piece of 1/8 brass welding rod, coat the tip with Loctite and drive it in one of the holes till it bottoms. Do the other 3 the same way. Take the clamp off.
Using a fine tooth jewlers saw cut the excess brass off of the pins. Now peen what is left down till it is flush.
Face and bevel the insert to finish size.
NO, you can't shim a bearing shell and expect it to live.