Quote:
Originally Posted by v8fordman
Here are a couple of pictures of the attachment that allows you to remove (or install) the front spring using a KRW spring spreader. Notice how it attaches which causes the overall length of the piece reaching the spring to become reduced. This works very well as most KRW tools do. As mentioned earlier, this is a VERY rare attachment for the KRW spring spreader. I've only seen two in my life.
|
V8 Fordman, I was lucky enough to find both of these versions and yes, they work well on the front. For someone who needs something available you can use the model a front spring or rear even upside down I believe. I have and use them in A’s all the time but use my kr Wilson rear unit in v8’s. I’m kind of a krw junkie so haven’t passed up too many over the years. Super glad I got them as they have been invaluable.
I didn’t know it till about 6 months ago but there’s a kr wilson Facebook group. You can post out there if you are looking for something. At least it’s a resource.
I think it’s harder to find them now than it was 20 years ago.
Larry