How to mount a vacuum wiper on a 1931 S/W Fordor
The wiper came separate from the car (1931 S/W Fordor).
The shaft on our car's vacuum wiper is about 3" long and about 1/4" in diameter.
About an inch from the end where the wiper arm attaches in a hole, the shaft is enlarged to 1/2" in diameter for about 1/2" long. Then, the shaft goes back to 1/4" diameter with threads for about 1/2" until the very end of the shaft's hole.
I know that the shaft goes through a hole in the wood header. The wiper resides inside the car.
How does the wiper mount?
Is there a metal tube that the shaft goes through in the header?
Is there only a rubber grommet, metal washer, and nut on the outside of the header to mount the wiper?
Any help would be appreciated.
Thanks.
|