The Ford Barn - View Single Post - How much endplay 59-a helmet distributor?

41panelmark · 04-10-2022, 09:16 PM

Thanks and yes it is out of a 40 , not a helmet but has the 2 caps. I also thought about the washer. If there was to much back n forth could that cause some misfire issues? I did notice that the contact that runs on the rotor rides at the very end or edge of the brass surface when the shaft is moved all of the way to one side.

04-10-2022, 09:16 PM	#4
41panelmark Senior Member Join Date: May 2010 Location: Colorado Posts: 1,264	Re: How much endplay 59-a helmet distributor? Thanks and yes it is out of a 40 , not a helmet but has the 2 caps. I also thought about the washer. If there was to much back n forth could that cause some misfire issues? I did notice that the contact that runs on the rotor rides at the very end or edge of the brass surface when the shaft is moved all of the way to one side.