The Ford Barn - View Single Post

wwirz · 01-30-2022, 07:47 PM

Remember that you have to have a measured 6V to the points. If you do not have this, it is likely the ignition switch or the wire from the ignition switch to the distributor.
Also, make sure the timing is not off. Sometimes the distributor cam moves. Make sure your timing is correct and your points are gapped at .020". If you have excessive gap, the car will not start (do not ask me how I know).
So:
. make sure you have 6V (measured with a meter) to the points
. Check the timing
. Check the point gap.
Do not rule out a bad condenser. Easily changed for piece of mind.

01-30-2022, 07:47 PM	#25
wwirz Senior Member Join Date: May 2020 Location: Corning NY Posts: 255	Re: Won't Start.... Remember that you have to have a measured 6V to the points. If you do not have this, it is likely the ignition switch or the wire from the ignition switch to the distributor. Also, make sure the timing is not off. Sometimes the distributor cam moves. Make sure your timing is correct and your points are gapped at .020". If you have excessive gap, the car will not start (do not ask me how I know). So: . make sure you have 6V (measured with a meter) to the points . Check the timing . Check the point gap. Do not rule out a bad condenser. Easily changed for piece of mind.