The Ford Barn - View Single Post

Badpuppy · 11-13-2021, 08:52 AM

What I don't like about the shorter cable is that it doesn't arc through the firewall properly after being clamped - points almost straight up. Wish i'd bought the longer cable, but I extended the armor with a length of 3/4" copper pipe and duct tape; worked ok. What I like about the skinny cable is it can be removed without pulling the distributor.

C'mon, it's not that hard to pull the dash. But wire is 16 ga. if you must.

11-13-2021, 08:52 AM	#2
Badpuppy Senior Member Join Date: Dec 2017 Location: Guthrie, OK Posts: 1,265	Re: Ignition Cable What I don't like about the shorter cable is that it doesn't arc through the firewall properly after being clamped - points almost straight up. Wish i'd bought the longer cable, but I extended the armor with a length of 3/4" copper pipe and duct tape; worked ok. What I like about the skinny cable is it can be removed without pulling the distributor. C'mon, it's not that hard to pull the dash. But wire is 16 ga. if you must.