The Ford Barn - View Single Post

fredeuce · 11-07-2021, 03:56 PM

I have looked through the gasket set but can not see any roll pin .

Does anyone have any pictures of how this is done?

I was thinking of fitting some small screws to the sump where the other half of the seal is located and driving them into the seal to capture that portion to prevent rotation.

Any thoughts on that idea?

11-07-2021, 03:56 PM	#10
fredeuce Member Join Date: May 2010 Location: South Australia Posts: 53	Re: Rear Main Seals I have looked through the gasket set but can not see any roll pin . Does anyone have any pictures of how this is done? I was thinking of fitting some small screws to the sump where the other half of the seal is located and driving them into the seal to capture that portion to prevent rotation. Any thoughts on that idea?