Re: Clear Distributor Cap
Good evening at all.
Unfortunately, I couldn't find anyone who sells a transparent manifold cover. Creating a file for 3-D part printing is too expansiv. So I now tried to cast it by myself from epoxy resin.
I made the mold from two-component silicone rubber for third dentures from the original lid.
Unfortunately, the first attempt did not work. I had filled too less casting resin, too less vent holes on the upside mold and used an unsuitable wax for separation.
No. # 2 has been cast in the mean time and must now cure in the mold. I will report.
__________________
Beste Gruesse aus Deutschland,
Werner
Ford Model A, Roadster, 1928
Citroen 11 CV, 1947
Hercules W 2000, 1976; (with NSU-Wankel Rotary Engine), Canadian version
|