The Ford Barn - View Single Post - 1932-1934 pickup window channel installation questions

Ideucev8 · 09-02-2021, 06:19 PM

Hi, the hook end is the top. I had to bend the hook out at right angles to the channel then insert the bottom end into the hole & pull the channel up. then bend the hook over at the top. Mine were vintique & fitted good.
There should be a bracket riveted to the inside door panel at the bottom of the access hole that the bumper goes into. It goes at right angles to the glass.
The little bumpers go into a slot in the door were the glass rises through on the inside edge.
Not all the pickup doors have the slot for them.
Phil.

09-02-2021, 06:19 PM	#3
Ideucev8 Member Join Date: Jan 2018 Location: Kaikoura New Zealand Posts: 59	Re: 1932-1934 pickup window channel installation questions Hi, the hook end is the top. I had to bend the hook out at right angles to the channel then insert the bottom end into the hole & pull the channel up. then bend the hook over at the top. Mine were vintique & fitted good. There should be a bracket riveted to the inside door panel at the bottom of the access hole that the bumper goes into. It goes at right angles to the glass. The little bumpers go into a slot in the door were the glass rises through on the inside edge. Not all the pickup doors have the slot for them. Phil.