Quote:
Originally Posted by RTC1930
Can any one describe what the head of the tubular rivet tool should look like. Is it rounded or chamfered? I think I may try to weld a pin to an old set of channel locks I have so I can squeeze the tubular rivets into the hood bumpers and corner leather. Not sure it will work but hood is installed and i'd rather not take it off to use a hammer.
Thanks,
Bob NJ
|
There is one or more right now on e-Bay. It is posed on a break shoe, but it is made for tube rivets. I thank last night it was about 10.00. Herm.