The Ford Barn - View Single Post

RTC1930 · 04-30-2011, 10:16 AM

Can any one describe what the head of the tubular rivet tool should look like. Is it rounded or chamfered? I think I may try to weld a pin to an old set of channel locks I have so I can squeeze the tubular rivets into the hood bumpers and corner leather. Not sure it will work but hood is installed and i'd rather not take it off to use a hammer.

Thanks,
Bob NJ

04-30-2011, 10:16 AM	#1
RTC1930 Senior Member Join Date: May 2010 Location: Stockholm, NJ Posts: 106	Tubular Rivet Tool Can any one describe what the head of the tubular rivet tool should look like. Is it rounded or chamfered? I think I may try to weld a pin to an old set of channel locks I have so I can squeeze the tubular rivets into the hood bumpers and corner leather. Not sure it will work but hood is installed and i'd rather not take it off to use a hammer. Thanks, Bob NJ __________________ "Fix what's broken"