Quote:
Originally Posted by flathead 53
The pressed steel bell housing used on some 51/53 flatheads , what is the correct installation of the clutch arm , you have the clutch arm , the spring that goes over it , then there is A metal plate that also goes on the arm and goes to the outside of the bell ,then there is a felt material that goes under the metal plate , is this correct .
|
First, the stamped steel full bell was only used on '49-'51 Ford cars.
You are correct about the assembly: Clutch arm, anti-rattle spring 7562, plate 7513, and pad 7996. The '49-'51 shop manual shows the entire assembly.