[d.j. moordigian]

Originally Posted by Michael_Velling

Hello, i have a question about the connecting rods with inserts.

I want to have the crankshaft ground to the correct size and then install the connecting rods with new pistons. Of course, the cylinders will be ground to the correct size for the new pistons.

Is it possible to do this so easily?

Thanks

Michael
Germany

Install the bearings in the rods(all of them) and torque them. Using a "dial
bore" measure it on the vertical. Then, with those figures SUBTRACT the
number from what clearance that you want AND that's what you grind the
crank too.........make sense?

djm