Sponsored Links (Register now to hide all advertisements)
Here are a few more photos I just took. In photos 1,2 5 and 6 you are looking at the trunk lip as viewed from inside the trunk on the driver side with the thin metal lip showing. Photos 3 and 4 are the views from outside the trunk. There is a small amount of adhesive sealant shown in photo 2. The thin side of the seal fits over the sheet metal lip on the perimeter of trunk opening. Note: As I recall the seal is longer than needed so you can cut off a short piece and "test fit" it. The yellow stuff looks like I did use some 3M weatherstrip adhesive.