12-07-2020, 03:17 PM
|
#24
|
BANNED
Join Date: May 2010
Location: Wa.
Posts: 5,423
|
Re: Bad Stud thread
Quote:
Originally Posted by BRENT in 10-uh-C
The way I took it (-when Katy suggested annealing) was "Can this also be done on a graphite gasket?" -as in can this be done on this type gasket also.
I will tell you straight-up that the Model-A deck surface will NOT hold 75 lbs of torque without distorting.
>Tell that to several circle track guys and the guy that was top fuel 4 banger
eliminator at the Antique Nationals a couple of times.
Pete, since the Model-A block uses studs that are stationary, are you/we referring to rust inside the threads of the block affecting torque values??
|
Yes.
|
|
|