Re: Model A Ford Trunks
Ed, you’re far from me but I found some 1/8” at Austin Hardwood out here in Southern CA. They called it wiggle wood. It bends easily, but I still had to steam it on the sharp radius. What I don’t like about it is flimsy. I glued mine 3 ply thick with plenty of TiteBond III. I still had to steam it on the tight radius. I just finished mine btw. I didn’t use the plans, instead went by dimensions and pictures in the Service Bulletins pg 364 and in the section of accessories of the JS & RG. Mine fits the original Ford accessory rack that is a couple inches narrower at 33” wide, 16” deep, and 19” tall.
Last edited by denniskliesen; 10-10-2020 at 01:43 PM.
|