04-05-2020, 01:36 PM
|
#15
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,877
|
Re: Continued Decussion on Murray Damper
Quote:
Originally Posted by Jack Shaft
Put one of murrays on my car. Can feed a B width belt sideways to install. Bronze cam gear chatter minimized. Logic says reducing harmonic vibration should help extend main bearing life with a dynamically balanced crankshaft.. time will tell.
|
Quote:
Originally Posted by Synchro909
I have had one of those on one of my cars for quite a while now and I think it certainly does smooth things out some. BTW, I can remove and fit a belt without either raising the front of the engine or removing the U bolts but it is tight.
|
Finished up on the Harmonic Balancer installation and took the Ol' Girl for a ride. I was surprised that the engine did seem to run smoother throughout the RPM range, especially at the higher end. I decided to leave the segmented bely on also. As an added bonus, with the reverse spiral it seemed to cure a slight oil leak I had from the front seal. I think this is one of my better additions to my engine.
Now to go finish up. It is amazing how loud and warm it is when the floor insulation and carpet is not installed.
|
|
|