Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by Kohnke Rebabbitting
I like the bearings [ rods and mains] at .0015" [ no more than .002"] with each side of the shim pack equal thickness.
|
Me too.
Herm.[/QUOTE]
I think I understand what you were trying to say, but, there was still some question. I understand about the 'bow', I'm not a big fan of that 60# wheel and only 3 bearings. But thats 1930s stuff and what we have to deal with. Every bearing I adjust I then make sure the crank turns freely. Maybe we're just taking different directions to get to the same place.