The Ford Barn - View Single Post - Replace Flathead with Y-Block?

koates · 10-08-2019, 10:44 PM

Well I wasn't going to say anything for fear of recrimination, but this story has run along for more than 60 posts (which shows the interest here) but we are more about original and restored flathead ford V8s with only minimal modifications. So I am thinking we should be sticking to just that. Plenty of hot rod and custom car forums around for buggered up cars. There, now you can whack me if you like. Regards, Kevin.

10-08-2019, 10:44 PM	#63
koates Senior Member Join Date: May 2010 Location: Melbourne Australia. Posts: 2,218	Re: Replace Flathead with Y-Block? Well I wasn't going to say anything for fear of recrimination, but this story has run along for more than 60 posts (which shows the interest here) but we are more about original and restored flathead ford V8s with only minimal modifications. So I am thinking we should be sticking to just that. Plenty of hot rod and custom car forums around for buggered up cars. There, now you can whack me if you like. Regards, Kevin.