The Ford Barn - View Single Post

gilitos · 09-14-2019, 10:42 PM

Ron rebuilt my engine In '85 and it was so tight that I had to tow the car to get it started; the starter motor couldn't turn it over. The main bearings broke up within a few thousand miles. He rebuilt it again (full price) and they failed again within a few thousand miles; this time it was also tight, but the main cause was the crank was set so far forward that the flywheel bolts hit the thrust bearing and destroyed it. Ugh. He said he would take care of it but I declined his offer. Too many rebuilds in too few miles.

09-14-2019, 10:42 PM	#4
gilitos Senior Member Join Date: May 2010 Location: Cincinnati, OH Posts: 224	Re: babbit tolerance? .000? Ron rebuilt my engine In '85 and it was so tight that I had to tow the car to get it started; the starter motor couldn't turn it over. The main bearings broke up within a few thousand miles. He rebuilt it again (full price) and they failed again within a few thousand miles; this time it was also tight, but the main cause was the crank was set so far forward that the flywheel bolts hit the thrust bearing and destroyed it. Ugh. He said he would take care of it but I declined his offer. Too many rebuilds in too few miles.