The Ford Barn - View Single Post

Patrick L. · 09-08-2019, 08:42 AM

I've scraped large babbit bearings. You just keep marking and scraping to 'bed' them.

But I don't do that to adjust a small bearing such as ours. I like ours to end up at .0015"

09-08-2019, 08:42 AM	#3
Patrick L. Senior Member Join Date: May 2010 Location: Largo Florida Posts: 7,225	Re: babbit tolerance? .000? I've scraped large babbit bearings. You just keep marking and scraping to 'bed' them. But I don't do that to adjust a small bearing such as ours. I like ours to end up at .0015"