The Ford Barn - View Single Post

Andy · 08-04-2019, 10:16 AM

Tubman, !!!!! CORRECT!!!!
I thought my engine would never give up the heads put on with copper coat.I had to drive wedges in all around the heads. I was sure I was going to crack the block or warp the heads. The gaskets were so solidly adhered that they had to seperate down the middle.

08-04-2019, 10:16 AM	#5
Andy Senior Member Join Date: May 2010 Location: Kerrville, Tx Posts: 2,919	Re: Need to replace headgasket Tubman, !!!!! CORRECT!!!! I thought my engine would never give up the heads put on with copper coat.I had to drive wedges in all around the heads. I was sure I was going to crack the block or warp the heads. The gaskets were so solidly adhered that they had to seperate down the middle.