The Ford Barn - View Single Post

tubman · 04-29-2019, 07:30 AM

I wouldn't think they would be too hard to fabricate, would they? A 2" slice off a 6" (or so) steel pipe and some 1/4" X 2" steel strap and you're well on your way to making the first (circular) part. A piece of the proper sized tubing, a steel plate, and some proper sized bolts and you have the second. Granted, it would take some cutting and welding, but if I had the stand without those parts, I would be at the steel supply shop this afternoon, digging through the "Drops" bin.

04-29-2019, 07:30 AM	#18
tubman Senior Member Join Date: Dec 2013 Location: Minnesota, Florida Keys Posts: 12,143	Re: flathead engine cradle I wouldn't think they would be too hard to fabricate, would they? A 2" slice off a 6" (or so) steel pipe and some 1/4" X 2" steel strap and you're well on your way to making the first (circular) part. A piece of the proper sized tubing, a steel plate, and some proper sized bolts and you have the second. Granted, it would take some cutting and welding, but if I had the stand without those parts, I would be at the steel supply shop this afternoon, digging through the "Drops" bin.