The Ford Barn - View Single Post

Ol' Ron · 03-12-2019, 01:47 PM

The stock Ford head stud had only 8/10 threads on the course end. This was so you could tighten the stud to the deck to prevent leaking. When using the studs you should torque them to the block 10/15 lbs with a sealer. This should solve your problems. I don't use studs so I don't have to worry

03-12-2019, 01:47 PM	#16
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,985	Re: 59AB head stud question The stock Ford head stud had only 8/10 threads on the course end. This was so you could tighten the stud to the deck to prevent leaking. When using the studs you should torque them to the block 10/15 lbs with a sealer. This should solve your problems. I don't use studs so I don't have to worry