The Ford Barn - View Single Post

macdonge · 12-27-2018, 08:13 AM

Russcc: If all I had to work with was a bare block, I agree with you. In my case, however, I have a perfectly good crank & rod set (original to the engine).

Sent from my iPhone using Tapatalk

12-27-2018, 08:13 AM	#72
macdonge Senior Member Join Date: May 2015 Location: Frelighsburg, QC Posts: 167	Re: Bearing clearance Russcc: If all I had to work with was a bare block, I agree with you. In my case, however, I have a perfectly good crank & rod set (original to the engine). Sent from my iPhone using Tapatalk