The Ford Barn - View Single Post

Ol' Ron · 12-01-2018, 12:41 PM

Yes, for floaters, I run about .002 on both the rods and crank. I open the rods to 2.221 and the crank to 1.997. OR find bearings that are .1o8" thick. That's why fitting the bearings are important. Again, I have dozens of used bearigs to choose from

12-01-2018, 12:41 PM	#28
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,985	Re: Bearing clearance Yes, for floaters, I run about .002 on both the rods and crank. I open the rods to 2.221 and the crank to 1.997. OR find bearings that are .1o8" thick. That's why fitting the bearings are important. Again, I have dozens of used bearigs to choose from