View Single Post
Old 08-03-2018, 01:39 PM   #75
poolplayer1
Senior Member
 
Join Date: Sep 2015
Posts: 399
Default Re: 1955 ford station wagon with a V8 302 Engine.

The water pump I put in is a new water pump from master Pro. The new thermostat is 180 degrees.The new radiator cap is a 13 psi cap which it calls for. Still waiting for the Rad.to come back. I found some casting numbers on the old water pump and they are; C8AE-J. I did some research and it looks like this pump was used in the 68 ford model cars that had AC. Would it matter if the new pump is for non-ac motors? Again I matched the old pump to the new one and they both are the same.The only difference is the pulley hub on the old pump is a 2 1/2" and the new hub is 2".
However,the pulley bolt holes match the new hub hole pattern so I don't think that its a problem,unless you think it might make a difference. I tried to find a new water pump from different parts houses by putting in the C8AE-J numbers on the search bar but nobody came up with a cross for it. As usuall,thanks to all for your good advice and suggestions.
Mando
poolplayer1 is offline   Reply With Quote